MPO cable Archive


something about optic fiber Splicing

pending image

A splice is a device to connect one fiber optic cable to another permanently. It is the attribute of permanence that distinguishes a splice from connectors. Nonetheless, some vendors offer splices that can be disconnected that are not permanent so that they can be disconnected for repairs or rearrangements. The terminology can [ Continue reading…]


BASIC CABLE DESIGN

pending image

1 – Two basic cable designs are:   Loose-tube cable, used in the majority of outside-plant installations in North America, and tight-buffered cable, primarily used inside buildings.   The modular design of loose-tube cables typically holds up to 12 fibers per buffer tube with a maximum per cable fiber count of more [ Continue reading…]



What’s the best way to terminate fiber optic cable?

pending image

What’s the best way to terminate fiber optic cable? That depends on the application, cost considerations and your own personal preferences. The following connector comparisons can make the decision easier.Epoxy & PolishEpoxy & polish style connectors were the original fiber optic connectors. They still represent the largest segment of connectors, in both [ Continue reading…]


BASIC CABLE DESIGN

pending image

1 – Two basic cable designs are:   Loose-tube cable, used in the majority of outside-plant installations in North America, and tight-buffered cable, primarily used inside buildings.   The modular design of loose-tube cables typically holds up to 12 fibers per buffer tube with a maximum per cable fiber count [ Continue reading…]


The Ports On CWDM and DWDM MUX/DEMUX

pending image

It is quite common to use CWDM or DWDM to increase the existing fiber optic network without adding any fibers. Using WDM MUX/DEMUX is necessary to build a CWDM or DWDM network. Now there are different ports installed on the CWDM and DWDM MUX/DEMUXs to add more beneficial to the fiber optic [ Continue reading…]



Guideline for Copper Cabling Installation

pending image

Copper cabling has been in use since electricity was invented and its quality has continued to improve. Network managers pick copper cabling for various reasons. For instance, copper cables, especially UTP cables, are as inexpensive as optical fibers and easy to install. Moreover, the installation methods are well understood, and the components [ Continue reading…]


Common Types Of Fiber Optic Cables And Patch Cables

pending image

1.FTTH Fiber Optic Cable   FTTH (Fiber To The Home), as its name suggests it is a fiber optic directly to the home. Specifically, FTTH refers to the optical network unit (ONU) mounted on home users or business users, is the optical access network application type of closest to users [ Continue reading…]


Typical Outdoor Fiber Optic Cables

pending image

Fiber optic cable provides protection for the fibers from the environment encountered in an installation. Outdoor Fiber Cable is designed strong to protect the fibers to operate safely in complicated outdoor environment, it can be buried directly, pulled in conduit, strung aerially or even placed underwater. While indoor cables don’t have [ Continue reading…]


Why Use Tunable DWDM SFP+ Transceivers?

pending image

http://www.fiber-mart.com/fiber-optic-transceivers-sfp-transceivers-c-1_2.htmlThe tunable DWDM SFP+ is one kind of DWDM SFP+ transceivers. They both can be used in the DWDM system. In the market, tunable DWDM SFP+ transceivers are often between two and four times more expensive than DWDM SFP+ transceivers. Thus, many may think DWDM SFP+ transceivers are enough in [ Continue reading…]


Will Single-mode Fiber Work Over Multimode SFP Transceiver?

pending image

Network installers usually come across a situation that device you have in your network does not always fit and work perfectly with the fiber. They plan to make a cable plant based on the multimode cabling, but owing to the link limitation or other reasons, they have to connect multimode [ Continue reading…]